HP 75000 SERIES C User Manual

- Printing History
The Printing History shown below lists all Editions and Updates
of this manual and the printing date(s). The first printing of the
manual is Edition
1.
The Edition number increments by 1 whenever the manual is revised.
Updates, which are issued between Editions, contain replacement
pages to correct the current Edition of the manual. Updates are
numbered sequentially starting with Update
1. When a new Edition
is created, it contains
all the Update information for the previous
Edition. Each new Edition or Update also includes a revised copy of
this printing history page. Many product updates or revisions do
not require manual changes and, conversely, manual corrections may
be done without accompanying product changes. Therefore, do not
expect a one-to-one correspondence between product updates and
manual updates.
Control Serial Number: Edition
2 applies directly to all instruments.
Printing History
Edition Date Part Number CODE
Edition 1 May 1990 E1440-90011 E0590
Edition
2 April 1992 E1440-90011 E0492
This product has been designed and tested according to International
Safety Requirements. To ensure safe operation, and to keep the
product safe, heed the symbols, warnings and cautions contained in
this section.
Operational Safety
The following general safety precautions must be observed during
all phases of operation, service, and repair of this product. Failure
to comply with these precautions or with specific warnings elsewhere
in this manual violates safety standards of design, manufacture, and
intended use of the product. Hewlett-Packard Company assumes no
liability for the customer's failure to comply with these requirements.
DO NOT operate the product in an explosive atmosphere or in the
presence of flammable gases or fumes.
Keep away from live circuits: Operating personnel must not remove
equipment covers or shields. Procedures involving the removal of
covers or shields are for use by service-trained personnel only. Under
certain conditions, dangerous voltages may exist even with the
equipment switched off.
To avoid dangerous electrical shock, DO NOT perform procedures
involving cover or shield
removal unless you are qualified to do so.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

HP 75000 SERIES C Specifications

General

Brand	HP
Model	75000 SERIES C
Category	Inverter
Language	English