HP 75000 SERIES C User Manual

[:SOURce]:LIST
Subsystem Syntax
Note
d
The List command subsystem controls automatic sequencing through
associated lists of specified signal values which are specified by
the LIST command. The individual points defined in the list are
combined to produce one composite signal configuration.
:LIST
:FREQuency
:STARt <numeric list
>
:POINts? <query only>
:STOP <numeric list
>
:POINts? <query only>
:M ARKer <numeric list only>
:POINts? <query only>
:STATe <booleanlist>
:P OIN t s? <query only>
:SPACing din-log list
>
:POINts? <query only>
:DWELl <numericlist>
:POINts? <query only>
:SEQuence <extended numeric list
>
:POINts? <query only>
:LENGth? <query only>
--C
The lists :FREQ:STAR I STOP I MARK, DWEL, SEQ, are not
affected by *RST or SYSTTRE?? i.e. they do not change
:LIST:FREQuency
This command lists the frequency points of the list set. The
command has several subsets as follows:
:FREQuency:STARt is a numeric list of the start frequency for
each sweep of a multiple sweep. For example :FREQ:STAR 5,
1000, 10500 would specify three sweeps with individual start
frequencies of
5Hz
1 kHz and 10.5kHz.
:FREQ:STAR:POIN? would return the number of entries in the
START LIST.
:FREQuency:STOP is a numeric list of the stop frequency for each
sweep of a multiple sweep. This list must have an identical number
of entries to the start list and vice versa, unless the same value
applies to all entries, then the value need only be stated once and
the parser will apply that
value to each sweep in turn.
-
5-20 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

HP 75000 SERIES C Specifications

General

Brand	HP
Model	75000 SERIES C
Category	Inverter
Language	English