[SOURce]:PM
[SOURce]:PM
[:SOURce]:PM
The
:PM
command applies the phase modulation subsystem it is
used to allow an external modulation signal to set the modulation
controls of the HP
E1440A
and also the parameters associated with
the modulating signal.
Subsystem Syntax
[:SOURce]
:PM
:STATe <boolean>
Parameters
Parameter
I
I
Name
Type
I
Values
Comments
External
PM:
Is enabled with the :PM:STAT ON or :PM:STAT
1
command. Using this command does not automatically turn OFF
any other external modulation signal that may be in use.
Disable
PM:
Is
disabled with the :PM:STAT OFF or :PM:STAT
0
command.
Related command:
"RST (sets to OFF).
boolean
5-24
Command Reference
ONlOFFlllO
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
