HP 8591C - Step 4. Enter the Temperature

I
-
System Measurements
Making System Measurements
Step 4. Enter the temperature
1. Press ENTER TEMP
2. Press the data keys to enter the temperature. If you make a mistake, you
can use the back space key to correct the location code. The back space
key
(cm]) is onthe lower right corner of the analyzer’s front panel,
next to the (-1 key.
3. Press (ENTER) when the temperature has been entered.
ENTER TEMP allows you to enter the ambient temperature without the
Celsius or Fahrenheit units. This function is only for your convenience; it
is not necessary to enter the temperature when making a measurement.
The temperature you enter will be stored and printed with the data.
(The analyzer does not measure the temperature; you must provide the
temperature reading.)
5:49:56 NOV 23, 1993
ENTER Temperature using the keypad
(ENTER number,
then pressthe ENTER
key)
Figure 3-6. Enter Temperature Menu
3-11