I
-
System Measurements
Making System Measurements
b.
If you want the data printed, press DUMP to PRINTER . For
information about connecting the printer to the analyzer, see “Step 3.
Install a printer,” located in Chapter 1.
c. If you want the data to be saved on a RAM card, insert a RAM card in
the card reader, ensure that the RAM card has been formatted and the
write-protect switch is set so the RAM card is not write protected, then
press DUMP TO RAM CARD
See “Formatting a RAM Card” later in this chapter for information
about formatting a RAM card.
15:54:59
NOW
23, 1993
DUMP TO SCREEN
-
Test now
with
results
spnt
to
SoPee"
OUIIP
TO PRINTER
-
Test now with results
sent to printer
DUMP TO CARD
-
Test now with
rrrults
stored
P"
RbH
Card
Main Menu
-
Return to Main
Menu
DUMP TO
SCREEN
DUMP TO
PRINTER
DUMP TO
RhM CARD
Figure 3-8. Dump Options Menu
4.
If you want to stop the testing, press ABORT . It takes a few seconds for
the testing to stop after ABORT is pressed.
After measurements are completed, the following screen is displayed.
3-15
To Next Page
Loading...
Need help?
General
