I
-
System Measurements
Creating a Test Plan
l If you selected the carrier-to-noise and/or CSO test, enter the quiet line
number and odd, even, or both fields when prompted.
l If you selected the in-channel frequency response test, enter the
frequency response line number, odd, even, or both fields, and the
desired test signal type when prompted.
l If you selected a video test (differential gain, differential phase, and/or
chroma luma delay), enter the line number of the test signal, odd or
even field, and the desired test signal type when prompted.
NOTE
The same quiet line and test signal numbers selected here will be used for all selected channels when
using
ENTER BY RANGE.
7. After you have selected the test or tests, press DONE.
8.
If you want to view the selected channels, press VIEW
CH
SEL
You can enter channels into the test plan as individual channels or as a range
of channels. This procedure described how to enter a range of channels into
the test plan.
3-26
I-
To Next Page
Loading...
Need help?
General
