HP 9304m - Modifying Port Mode

Configuring Basic Features
4 - 21
The <value> can be one of the following:
•10-full
• 10-half
•100-full
• 100-half
•auto
The default is auto.
USING THE WEB MANAGEMENT INTERFACE
To modify port speed:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Click on the plus sign next to Configure in the tree view to display the configuration options.
3. Select the Port
link to display the Port table.
4. Click on the Modify button next to the row of information for the port you want to reconfigure.
5. Click next to Full Duplex if you want to change the mode to full-duplex only. (This applies only to 10/100
ports.)
6. Click Disable or Enable next to Auto Negotiate to enable or disable auto-negotiation.
7. Click Apply to save the changes to the device’s running-config file.
8. Select the Save
link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device’s flash memory.
Modifying Port Mode
You can configure a port to accept either full-duplex (bi-directional) or half-duplex (uni-directional) traffic. This
option is available only for 10/100 Mbps ports. The 100BaseFX, 1000BaseSX, and 1000BaseLX ports operate
only at full-duplex.
USING THE CLI
Port duplex mode and port speed are modified by the same command.
To change the port speed of interface 1/8 from the default of 10/100 auto-sense to 10 Mbps operating at full-
duplex, enter the following:
HP9300(config)# interface e 1/8
HP9300(config-if-1/8)# speed-duplex 10-full
Syntax: speed-duplex <value>
The <value> can be one of the following:
•10-full
• 10-half
•100-full
• 100-half
•auto
The default is auto.
USING THE WEB MANAGEMENT INTERFACE
To modify port mode: