Installation and Getting Started Guide
10 - 2
The version information is shown in bold type in this example.
• “07.5.00T53” indicates the flash code version number.
• “labeled as H2R07500” indicates the flash code image label. The label indicates the image type and version
and is especially useful if you change the image file name.
• “Primary H2R07500.bin” indicates the flash code image file name that was loaded.
Determining the Boot Image Version Running on the Device
To determine the boot image running on a device, enter the following command at any level of the CLI:
The boot code version is shown in bold type.
This command actually is showing the files installed on the management module’s flash memory. However, since
the boot code must be stored on the flash module, the boot code version listed here is also the version that the
device booted with.
Determining the Image Versions Installed in Flash Memory
Enter the show flash command to display the boot and flash images installed on the management module. An
example of the command’s output is shown in “Determining the Boot Image Version Running on the Device”.
• The “Compressed Pri Code size” line lists the flash code version installed in the primary flash area.
• The “Compressed Sec Code size” line lists the flash code version installed in the secondary flash area.
• The “Boot Image size” line lists the boot code version installed in flash memory. The device does not have
separate primary and secondary flash areas for the boot image. The flash memory module contains only one
boot image.
Image File Types
The following table lists the boot and flash image file types supported on each HP device. For information about a
specific version of code, see the release notes.
Upgrading Software
For easy software image management, all HP devices support the download and upload of software images
between the flash modules on the devices and a Trivial File Transfer Protocol (TFTP) server on the network.
The management module contains two flash memory modules:
Management Module Boot Image Flash Image
Redundant Management module
(J4845A, J4846A, J4847A, J4857A):
M2B07501.bin H2R0750x.bin
(for example, H2R07504.bin
HP9300> show flash
Active management module:
Code Flash Type: AMD 29F032B, Size: 64 * 65536 = 4194304, Unit: 2
Boot Flash Type: AMD 29F040, Size: 8 * 65536 = 524288
Compressed Pri Code size = 3265004, Version 07.5.00T53 (H2R0750x.bin)
Compressed Sec Code size = 3620593, Version 07.2.06T53 (H2R0750x.bin)
Maximum Code Image Size Supported: 3866112 (0x003afe00)
Boot Image size = 149436, Version 07.05.01 (bootrom.bin)
To Next Page
