HP 9304m - Displaying Gvrp Statistics

Installation and Getting Started Guide
8 - 14
To display detailed information for all VLANs, enter the show gvrp vlan all command.
Displaying GVRP Statistics
To display GVRP statistics for a port, enter a command such as the following:
Syntax: show gvrp statistics all | ethernet <port-num>
DEFAULT Whether this is the default VLAN.
BASE-VLAN Whether this is the base VLAN for GVRP.
Timer to Delete Entry Running Whether all ports have left the VLAN and the timer to delete the VLAN
itself is running. The timer is described in the note for the Leave timer
in “Changing the GVRP Timers” on page 8-7.
Legend The meanings of the letter codes used in other parts of the display.
Forbidden Members The ports that cannot become members of a VLAN advertised or
leaned by GVRP.
Fixed Members The ports that are statically configured members of the VLAN. GVRP
cannot remove these ports.
Normal(Dynamic) Members The ports that were added by GVRP. These ports also can be
removed by GVRP.
MODE The type of VLAN, which can be one of the following:
• STATIC – The VLAN is statically configured and cannot be
removed by GVRP. This includes VLANs you have configured as
well as the default VLAN (1), base GVRP VLAN (4093), and
Single STP VLAN (4094).
• DYNAMIC – The VLAN was learned through GVRP.
Table 8.4: CLI Display of Summary VLAN Information for GVRP (Continued)
This Field... Displays...
HP9300(config)# show gvrp statistics ethernet 2/1
PORT 2/1 Statistics:
Leave All Received : 147
Join Empty Received : 4193
Join In Received : 599
Leave Empty Received : 0
Leave In Received : 0
Empty Received : 588
Leave All Transmitted : 157
Join Empty Transmitted : 1794
Join In Transmitted : 598
Leave Empty Transmitted : 0
Leave In Transmitted : 0
Empty Transmitted : 1248
Invalid Messages/Attributes Skipped : 0
Failed Registrations : 0