Installation and Getting Started Guide
1 - 4
• Enhanced trunk group information display
• ACL packet and flow counters
• Option to add a comment to an ACL
• ACL permit logging
• Ability to display hardware serial numbers
•The show interfaces command displays an interface’s input and output load in terms of bits per second,
packets per second, and utilization percentage, averaged over a configurable interval
•The show ip interface command displays additional parameters for each interface
• A new command, show ip vrrp vrid, displays information for a specific VRP VRID and even for a specific port
configured with the VRID
•The show interfaces command show a virtual interface’s state as down if the interface’s VLAN is down
• Support for searching and filtering output from show commands
• Higher maximum number of Syslog buffer entries supported on Routing Switches
• IPv6 protocol VLAN support
• Support for empty VLANs
• Ability to configure the HP device to hide or show the RSA host key pair in the running-config file
• Support for TFTP source interface
• More flexible command syntax for clearing MAC addresses
• Support for Telneting to a specified port
• Ability to cancel an outbound Telnet session
• Support for reading Cisco Discovery Protocol (CDP) packets
• Enhanced show span output
• Enhanced show span vlan output
• New port number format in Web management interface
• Change to the SNMP community strings command: Specific views of the MIB can be assigned to community
strings
• Support for SNMP v3 (RFCs 2570 and 2575)
• New HP MIB objects: CPU utilization, Memory utilization, Software loads, SNMP trap holddown
Support and Warranty Information
Refer to
Support is as Close as the World Wide Web
, which was shipped with your HP Routing Switch.
To Next Page
Loading...
