HP 9304m - Displaying Neighbors

To Next Page

To Previous Page

Command Line Interface Reference

9 - 2

Displaying Neighbors

To display the Cisco neighbors the HP device has learned from CDP packets, enter the following command:

Syntax:

show fdp neighbors [detail | ethernet <portnum>]

To display detailed information for the neighbors, enter the following command:

To display information about a neighbor attached to a specific port, enter a command such as the following:

HP9300# show fdp neighbors

Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge

S - Switch, H - Host, I - IGMP, r - Repeater

(*) indicates a Cisco device

Device ID Local Int Holdtm Capability Platform Port ID

-------------- ------------ ------ ---------- ----------- -------------

(*)Router Eth 1/1 124 R cisco RSP4

FastEthernet5/0/0

HP9300# show fdp neighbors detail

Device ID: Router

Entry address(es):

IP address: 207.95.6.143

Platform: cisco RSP4, Capabilities: Router

Interface: Eth 1/1, Port ID (outgoing port): FastEthernet5/0/0

Holdtime : 150 seconds

Version :

Cisco Internetwork Operating System Software

IOS (tm) RSP Software (RSP-JSV-M), Version 12.0(5)T1, RELEASE SOFTWARE

(fc1)

Compiled Thu 19-Aug-99 04:12 by cmong

HP9300# show fdp neighbors ethernet 1/1