HP 9304m - Displaying Gvrp Information; Displaying Gvrp Configuration Information

Configuring GARP VLAN Registration Protocol (GVRP)
8 - 9
NOTE: After you convert the VLAN, the VLAN name changes from “‘GVRP_VLAN_<vlan-id>“ to
“STATIC_VLAN_<vlan-id>“.
Displaying GVRP Information
You can display the following GVRP information:
• GVRP configuration information
• GVRP VLAN information
• GVRP statistics
Displaying GVRP Configuration Information
To display GVRP configuration information, enter a command such as the following:
Syntax: show gvrp [ethernet <port-num>]
HP9300(config)# show gvrp
GVRP is enabled on the system
GVRP BASE VLAN ID : 4093
GVRP MAX Leaveall Timer : 300000 ms
GVRP Join Timer : 200 ms
GVRP Leave Timer : 600 ms
GVRP Leave-all Timer : 10000 ms
===========================================================================
Configuration that is being used:
block-learning ethe 1/3
block-applicant ethe 2/7 ethe 2/11
enable ethe 1/1 to 1/7 ethe 2/1 ethe 2/7 ethe 2/11
===========================================================================
Spanning Tree: SINGLE SPANNING TREE
Dropped Packets Count: 0
===========================================================================
Number of VLANs in the GVRP Database: 15
Maximum Number of VLANs that can be present: 4095
===========================================================================