Installation and Getting Started Guide
8 - 12
Displaying GVRP VLAN Information
To display information about all the VLANs on the device, enter the following command:
Syntax:
show gvrp vlan all | brief | <vlan-id>
VLAN Membership The VLANs of which the port is a member. For each VLAN, the
following information is shown:
• VLAN ID – The VLAN’s ID.
• Mode – The type of VLAN, which can be one of the following:
• FIXED – The port will always be a member of this VLAN and
the VLAN will always be advertised on this port by GVRP. A
port becomes FIXED when you configure the port as a
tagged member of a statically configured VLAN.
• FORBIDDEN – The VLAN is one of the special VLANs that is
not advertised or learned by GVRP. In the current release,
the following VLANs are forbidden: the default VLAN (1), the
GVRP base VLAN (4093), or the Single STP VLAN (4094).
• NORMAL – The port became a member of this VLAN after
learning about the VLAN through GVRP. The port’s
membership in the VLAN depends on GVRP. If the VLAN is
removed from the ports that send GVRP advertisements to
this device, then the port will stop being a member of the
VLAN.
Table 8.2: CLI Display of Detailed GVRP Information for a Port (Continued)
This Field... Displays...
HP9300(config)# show gvrp vlan brief
Number of VLANs in the GVRP Database: 7
Maximum Number of VLANs that can be present: 4095
[VLAN-ID] [MODE] [VLAN-INDEX]
1 STATIC-DEFAULT 0
7 STATIC 2
11 STATIC 4
1001 DYNAMIC 7
1003 DYNAMIC 8
4093 STATIC-GVRP-BASE-VLAN 6
4094 STATIC-SINGLE-SPAN-VLAN 5
===========================================================================
To Next Page
