Configuring Basic Features
4 - 43
Information for the configurable tables appears under the columns that are shown in bold type in this example. To
simplify configuration, the command parameter you enter to configure the table is used for the table name. For
example, to increase the capacity of the IP route table, enter the following commands:
HP9300(config)# system-max ip-route 120000
HP9300# show default values
sys log buffers:50 mac age time:300 sec telnet sessions:5
ip arp age:10 min bootp relay max hops:4 ip ttl:64 hops
ip addr per intf:24
when multicast enabled :
igmp group memb.:140 sec igmp query:60 sec
when ospf enabled :
ospf dead:40 sec ospf hello:10 sec ospf retrans:5 sec
ospf transit delay:1 sec
when bgp enabled :
bgp local pref.:100 bgp keep alive:60 sec bgp hold:180 sec
bgp metric:10 bgp local as:1 bgp cluster id:0
bgp ext. distance:20 bgp int. distance:200 bgp local distance:200
System Parameters Default Maximum Current
ip-arp 8000 64000 8000
ip-static-arp 1024 2048 1024
atalk-route 512 1536 512
atalk-zone-port 64 255 64
atalk-zone-sys 255 1024 255
dvmrp 2048 32000 2048
igmp 256 1024 256
ip-cache 128000 256000 128000
ip-filter-port 512 4096 512
ip-filter-sys 1024 8192 1024
ipx-forward-filter 256 1024 256
ipx-rip-entry 3072 32728 3072
ipx-rip-filter 256 1024 256
ipx-sap-entry 6144 32768 6144
ipx-sap-filter 256 1024 256
l3-vlan 32 2048 32
ip-qos-session 2048 32000 2048
l4-real-server 1024 2048 1024
l4-virtual-server 256 512 256
l4-server-port 2048 4096 2048
mac 8000 64000 8000
ip-route 128000 200000 128000
ip-static-route 512 2048 512
vlan 16 2048 16
spanning-tree 32 128 32
mac-filter-port 32 512 32
mac-filter-sys 64 1024 64
ip-subnet-port 24 128 24
session-limit 131072 500000 131072
view 10 65535 10
virtual-interface 255 2048 255
To Next Page
