HP 9304m - Page 182

Configuring Spanning Tree Protocol (STP)
6 - 25
spanning tree. VLAN 4094 is used only by SSTP. A port can be a member of VLAN 4094 and another port-based
VLAN at the same time without being tagged. All ports in VLAN 4094 share a common STP domain, but for all
other traffic, the ports remain within the separate Layer 2 broadcast domains established by the port-based
VLANs.
HP9300(config)# show span
port-vlan 2 is not in single spanning tree domain.
Global STP Parameters:
VLAN Root Root Root Prio Max He- Ho- Fwd Last Chg Bridge
ID ID Cost Port rity Age llo ld dly Chang cnt Address
Hex sec sec sec sec sec
800000e052f04f00 0 Root 8000 20 2 2 15 0 0 00e052f04f00
Port STP Parameters:
VLAN Port Prio Path State Fwd Design Design Design
ID Num rity Cost Trans Cost Root Bridge
Hex
1/1 80 0 DISABLED 0 0 0000000000000000 0000000000000000
1/2 80 0 DISABLED 0 0 0000000000000000 0000000000000000
1/3 80 0 DISABLED 0 0 0000000000000000 0000000000000000
1/4 80 0 DISABLED 0 0 0000000000000000 0000000000000000
.
. some lines omitted for brevity
.