Installation and Getting Started Guide
2 - 26
Searching and Filtering Output at the --More-- Prompt
The --More-- prompt is displayed when output extends beyond a single page. From this prompt, you can press the
Space bar to display the next page, the Return or Enter key to display the next line, or Ctrl-C or Q to cancel the
display. In addition, you can search and filter output from this prompt. For example:
HP9300# ?
append Append one file to another
appletalk-ping Ping AppleTalk node
attrib Change flash card file attribute
boot Boot system from bootp/tftp server/flash image
cd Change flash card working slot or current directory
chdir Change flash card working slot or current directory
clear Clear table/statistics/keys
clock Set clock
configure Enter configuration mode
copy Copy between flash, flash card, tftp, config/code
debug Enable debugging functions (see also 'undebug')
delete Delete flash card files
dir List flash card files
disable Disable a module before removing it
enable Enable a disabled module
erase Erase image/configuration from flash
exit Exit Privileged mode
fastboot Select fast-reload option
format Format flash card
gignpa Gigabit processor commands
hd Display hex dump of flash card file
kill Kill active CLI session
--More--, next page: Space, next line: Return key, quit: Control-c
At the --More-- prompt, you can press the forward slash key ( / ) and then enter a search string. The HP device
displays output starting from the first line that contains the search string, similar to the begin option for show
commands. For example:
--More--, next page: Space, next line: Return key, quit: Control-c
/telnet
The results of the search are displayed:
searching...
telnet Telnet by name or IP address
temperature temperature sensor commands
terminal display syslog
traceroute TraceRoute to IP node
undebug Disable debugging functions (see also 'debug')
undelete Undelete flash card files
whois WHOIS lookup
write Write running configuration to flash or terminal
To display lines containing only a specified search string (similar to the include option for show commands) press
the plus sign key ( + ) at the --More-- prompt and then enter the search string.
--More--, next page: Space, next line: Return key, quit: Control-c
+telnet
The filtered results are displayed:
filtering...
telnet Telnet by name or IP address
To display lines that do not contain a specified search string (similar to the exclude option for show commands)
press the minus sign key ( - ) at the --More-- prompt and then enter the search string.
To Next Page
Loading...
