Configuring Basic Features
4 - 7
HP9300(config)# snmp-server enable traps holddown-time 30
The command in this example changes the holddown time for SNMP traps to 30 seconds. The device waits 30
seconds to allow convergence in STP and OSPF before sending traps to the SNMP trap receiver.
Syntax:
[no] snmp-server enable traps holddown-time <secs>
The <secs> parameter specifies the number of seconds and can be from 1 – 600 (ten minutes). The default is 60
seconds.
USING THE WEB MANAGEMENT INTERFACE
You cannot configure the parameter using the Web management interface.
Disabling SNMP Traps
HP Routing Switches come with SNMP trap generation enabled by default for all traps. You can selectively disable
one or more of the following traps.
NOTE: By default, all SNMP traps are enabled at system startup.
• SNMP authentication key
• Power supply failure
•Fan failure
• Cold start
•Link up
•Link down
• Bridge new root
• Bridge topology change
• Locked address violation
• Module insert
• Module remove
•BGP4
• OSPF
•SRP
• VRRP
• VRRPE
USING THE CLI
To stop link down occurrences from being reported, enter the following:
HP9300(config)# no snmp-server enable traps link-down
Syntax:
[no] snmp-server enable traps <trap-type>
NOTE: For a list of the trap values, see the
Command Line Interface Reference
.
USING THE WEB MANAGEMENT INTERFACE
To enable or disable individual SNMP traps:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Select the Management
link to display the Management panel.
To Next Page
Loading...
