Configuring Basic Features
4 - 11
To display information about SNTP associations, enter the following command:
Syntax:
show sntp associations
The following table describes the information displayed by the show sntp associations command.
To display information about SNTP status, enter the following command:
Syntax:
show sntp status
The following table describes the information displayed by the show sntp status command.
Table 4.1: Output from the show sntp associations command
This Field... Displays...
(leading character) One or both of the following:
* Synchronized to this peer
~ Peer is statically configured
address IP address of the peer
ref clock IP address of the peer’s reference clock
st NTP stratum level of the peer
when Amount of time since the last NTP packet was received from the peer
poll Poll interval in seconds
delay Round trip delay in milliseconds
disp Dispersion in seconds
Table 4.2: Output from the show sntp status command
This Field... Indicates...
unsynchronized System is not synchronized to an NTP peer.
synchronized System is synchronized to an NTP peer.
stratum NTP stratum level of this system
HP9300# show sntp associations
address ref clock st when poll delay disp
~207.95.6.102 0.0.0.0 16 202 4 0.0 5.45
~207.95.6.101 0.0.0.0 16 202 0 0.0 0.0
* synced, ~ configured
HP9300# show sntp status
Clock is unsynchronized, stratum = 0, no reference clock
precision is 2**0
reference time is 0 .0
clock offset is 0.0 msec, root delay is 0.0 msec
root dispersion is 0.0 msec, peer dispersion is 0.0 msec
To Next Page
Loading...
