x
FCC Statement
This equipment has been tested and found to comply with the limits for either Class
A or Class B di
ital devices (refer to “Terminal Requirements Compliance”),
pursuant to Part 15 of the FCC Rules. These limits are desi
ned to provide
reasonable protection a
ainst harmful interference in a residential installation. This
equipment
enerates, uses, and can radiate radio frequency ener
y and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
uarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turnin
the equipment off and on, the user is encoura
ed to try to correct the
interference by one or more of the followin
measures:
• Reorient or relocate the receivin
antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment in to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution
Chan
es or modifications not covered in this manual
must be approved in writin
by the manufacturer’s
Re
ulatory En
ineerin
department. Chan
es or
modifications made without written approval may void
the user’s authority to operate the equipment.
Terminal Requirements Compliance
T1000 terminals meet Class B requirements.
Canadian DOC Notices
Refer to the previous section, “Terminal Requirements Compliance,” to determine
what class requirement the T1000 terminal meets.
Class A
This di
ital apparatus does not exceed the Class A limits for radio noise emissions
from di
ital apparatus set out in the Radio Interference Re
ulations of the
Canadian Department of Communications.
To Next Page
Loading...
