2
T1000 Terminal Installation
This section discusses the procedures for installin
the T1000 modular terminal.
This terminal can be freestandin
or, optionally, mounted on a wall. It can instead
be permanently mounted on a desktop, if desired. The followin
para
raphs
describe how to connect and set up the terminal in all three confi
urations.
Locating the Terminal
Position the terminal on a clean, horizontal surface that is free from vibration and
out of direct sunli
ht. Refer to “Windows-based Terminal Specifications” for
environmental specifications.
Connecting the Terminal
Make all connections to the back panel before connectin
the terminal to power. A
shroud (described in “Shroud Attachment”) can be installed after the cables are
connected and the terminal is mounted in place. Fi
ure 2-1 shows the terminal’s
back panel connectors.
To Next Page
Loading...
