HP Compaq t1000 - The Upgrade Process; 27 SNMP Firmware Upgrades

161
The Upgrade Process
1.
Press the
F2
key for the
Terminal Properties
dialo
g
box.
2.
Click on the
Network
tab.
3.
Click on the
Obtain an IP Address from DHCP Server
radio button, if the
function is not enabled.
4.
Click on the
Apps
tab.
5.
Click on the
DHCP Automatic Update Enable
check box on the
Apps
properties sheet, if the function is not enabled.
Note
You have now enabled the automatic DHCP function.
You will also need to confi
g
ure your DHCP option IDs.
SNMP Option IDs
Group box used to set the followin
g
SNMP option IDs:
•
Trap Server IP List
•
Set Community
Terminal Emulation
Option IDs
Group box used to set the followin
g
terminal emulation
option IDs:
•
Emulation Mode
•
Terminal ID
Virtual Port Option
IDs
Group box used to set the followin
g
virtual port option
IDs:
Server
Reset To Defaults
Click on this command button to reset all option IDs to
the default values.
Note
The values shown in Fi
g
ure 28-1 are the
terminal default values.
Table 28-1 Change DHCP Option IDs Dialog Box, Continued
Function Description