156
Firmware Up
rades
Using the SNMP Network Administration Dialog Box
To invoke this dialo
box:
1.
Press the
F2
key to invoke the
Terminal Properties
dialo
box.
2.
Click on the
Apps
tab to invoke the
Apps
properties sheet.
3.
Click on the
SNMP Network Administration
command button.
The followin
table discusses the functions of this dialo
box.
Table 27-1 SNMP Network Administration Dialog Box
Function Description
SNMP
Communication
Use this
roup box to set up SNMP communication
usin
the followin
functions:
Enable Authenticating Failure Trap
Check this box to enable the authenticatin
failure trap.
Community
Use this
roup box to confi
ure the network
mana
ement of a community.
Get
This field takes the name of the community the SNMP
mana
ement software will mana
e with read
permission only. If this field is left blank, the community
for that terminal will be public. The default for this field
is
Public
.
Set
This field contains the name of the community the
SNMP mana
ement software will mana
e with write
permission. By default, the set community that the
terminal belon
s to is called
WBTADMIN
. The default
for this field is
WBTADMIN
.
Note
All
Get
and
Set
names are case sensitive.
Trap Destination
Server 1:
,
Server 2:
,
Server 3:
, and
Server 4:
are
fields that supply the names or IP addresses of the
servers to which the terminal sends SNMP traps.
To Next Page
Loading...
