HP Compaq t1000 - Shroud Attachment

13
1.
Use the wall-mount bracket as a template to determine the positions of the
mountin
g
holes on the wall, then mark the locations of the mountin
g
holes.
Note
When determinin
g
location, take into account the cable
len
g
ths of the monitor, keyboard, mouse, power supply,
and peripherals.
2.
Install the (user-provided) wall anchors. Any standard anchorin
g
method may
be used, such as screws, butterfly anchors, or expansion bolts.
3.
Install the anchor screws. The anchor screw heads must have just enou
g
h
clearance to allow the bracket to slip onto them when han
g
in
g
the assembled
terminal (see the Note above).
4.
Insert the tabs at the top of the mountin
g
bracket into the slotted holes in the
back of the terminal housin
g
.
5.
Swin
g
the mountin
g
bracket to the side of the terminal.
6.
Insert the mountin
g
bolts up throu
g
h the holes in the bottom of the mountin
g
bracket and into the threaded holes in the terminal base plate.
7.
Ti
g
hten the mountin
g
bolts to hold the bracket firmly in place.
8.
Han
g
the terminal assembly on the wall-anchor mountin
g
screws.
9.
Install the cable retainin
g
loop and shroud usin
g
the procedure below.
Shroud Attachment
The plastic shroud may be installed to conceal the cable connectors at the rear of
the terminal housin
g
.
Proceed as follows:
1.
Attach the cables to their respective connectors on the back panel of the
terminal (see “Connectin
g
the Terminal”).
2.
Install the shroud-mountin
g
clips.
3.
Gently pull the lower ends of the shroud apart and place it over the cables.
4.
Place the slots in the lower end (split end) of the shroud under the lower shroud
mountin
g
clip.
5.
Rotate the upper end of the shroud until the top slot
g
oes over and en
g
a
g
es the
upper mountin
g
clip.