HP Compaq t1000 - Auto Download

145
3.
Power-up the terminal to initiate the download.
The
Firmware Upgrade
dialo
g
box appears, showin
g
that the download is in
pro
g
ress. When the download is complete, disconnect the parallel cable. The
Setup Wizard
will appear.
Note
If the download dialo
g
box remains on the screen
lon
g
er than 1 minute, press the
Enter
key. A prompt to
repeat or quit the operation appears. If the download
fails, quit the procedure, check all cables and
connections, then repeat from Step 2.
Auto Download
Use the followin
g
instructions to perform an auto download:
1.
Lo
g
on to the root of the drive where the installation batch file resides (usually
D:).
2.
Type install at the DOS prompt, then press
Enter
. The
Download Utility
dialo
g
box appears and the install pro
g
ram prompts you throu
g
h the download
procedures.
3.
When you are finished with your download, disconnect the LapLink cable and
reconnect the peripheral cables.
4.
Power-up the terminal and reconfi
g
ure its communications and options settin
g
s.
5.
Check the
About
dialo
g
box to verify the download revision.