HP Compaq t1000 - Using the Setup Wizard; Initial Terminal Setup

3
Initial Terminal Setup
The
Setup Wizard
is used for initial setup of the terminal’s properties. The wizard
runs when:
• You power-up your terminal for the first time.
• Your terminal has been restarted with a
G
key reset.
• A new ima
g
e has been downloaded to your terminal but is older than the ima
g
e
currently in use.
• You use the
Reset the Terminal to Factory-Default Property Settings
function on the
General
properties sheet.
Using the Setup Wizard
The
Setup Wizard
lets you set terminal network confi
g
uration and terminal display
parameters. There are six dialo
g
boxes that display in succession durin
g
the
process. Each dialo
g
box is self-explanatory. Some dialo
g
boxes are informational
and require no user input. Other dialo
g
boxes will prompt you for network and
display information. See Fi
g
ure 3-1 to view the first dialo
g
box of the wizard.
Note
Any future chan
g
es can be made usin
g
the
Terminal
Properties
dialo
g
box. You can launch this dialo
g
box
from the
T1000 Connection Manager
by pressin
g
the
F2
key. See “Resettin
g
Terminal Properties.”