HP Compaq t1000 - AT Commands Beginning with

202
Gettin
g
Help
Table 39-2 AT Commands Beginning with “&”
Command Description
&B1 Disable port rate adjust
&C1 Carrier detect follows data carrier
&D2 Han
g
up and
g
o to command mode durin
g
On-to-Off
DTR transition
&F, &F0 Recall factory settin
g
s as active confi
g
uration
&M0 Asynchronous mode
&N, &N0 Microcom QX/4232hs-compatible numeric result codes
displayed
&Q5 Error Correction Mode V.42=> MNP=> Async
&T4 Grant request from remote for remote di
g
ital loopback
test
&U1 Data compression enabled
&V View active confi
g
uration, profiles (0,1), and numbers
&W, &W0 Save active confi
g
uration as User Profile 0
&Y, &Y0 Recall User Profile 0 on power-up
Table 39-3 AT Commands Beginning with “\”
Command Description
\A3 Maximum MNP block size = 256 characters
\G, \G0 Disable port flow control DCE to DCE
\J, \J0 Disable port rate adjust
\L, \L0 MNP stream link
\N7 Set Auto-reliable mode (LAPM with fallback to MNP,
then to normal)