HP Compaq t1000 - Page 221

191
Reset your terminal:
1.
Press
F2
on your keyboard to invoke the
Terminal Properties
dialo
g
box.
2.
Click on (to check) the
Reset the Terminal to Factory Default Property
Settings
check box.
3.
Click on
Yes
in the
System Settings Change
dialo
g
box.
or
Reset the terminal to factory default by performin
g
the followin
g
steps while the
power is still on and while holdin
g
down the
G
key on the keyboard of your
terminal:
1.
Press and hold the power mana
g
ement button until the LED turns to amber
(approximately 3 to 5 seconds).
2.
Release the power mana
g
ement button.
3.
Wait approximately 7 seconds for the system to reboot.
4.
Wait for the
Setup
wizard to display, then release the
G
key.
The terminal is reset to factory defaults.
Determine the size of the onboard memory:
1.
Press
F2
on your keyboard to invoke the
Terminal Properties
dialo
g
box.
2.
Read the firmware revision number listed in
RAM:
on the
General
properties
sheet.
3.
Click on the
Close
command button on the
General
properties sheet to
return to
T1000 Connection Manager
.
Confi
g
ure a local printer:
If you are usin
g
the Winframe 1.7/ICA platform:
1.
Lo
g
in to your Winframe server.
2.
Click on
Print Manager
in
Program Manager
.
3.
Click on
Connect to Printer
on the
Printer
menu.
4.
Click on
Client Network
, then
Client
on the
Shared Printer
menu.
5.
Select your <clientname#port>, then click on
OK
.