To Next Page

To Previous Page

11-12

Port Trunking

Port Status and Configuration

Listing Static LACP and Dynamic LACP Trunk Data. This command

lists data for only the LACP-configured ports.

Syntax: show lacp

In the following example, ports A1 and A2 have been previously configured

for a static LACP trunk. (For more on “Active”, see table 11-5 on page 11-20.)

Figure 11-6. Example of a Show LACP Listing

Dynamic LACP Standby Links. Dynamic LACP trunking enables you to

configure standby links for a trunk by including more than the maximum

number of allowed ports in a dynamic LACP trunk configuration. When the

maximum number of allowed ports (trunk links) are up, the remaining link(s)

will be held in standby status. If a trunked link that is “Up” fails, it will be

replaced by a standby link, which maintains your intended bandwidth for the

trunk. (See also the “Standby” entry under “Port Status” in table 11-5, "LACP

Port Status Data", on page 11-20.) In the next example, ports A1 through A5

have been configured for the same dynamic LACP trunk, even though a

maximum of four ports are allowed in a trunk by the switch. Notice that one

of the links shows Standby status, while the remaining four links are “Up”.

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General