To Next Page

To Previous Page

12-34

Configuring for Network Management Applications

LLDP (Link-Layer Discovery Protocol)

Displaying Port Configuration Details. This command displays the port-

specific configuration, including.

Figure 12-11. Example of Per-Port Configuration Display

Syntax show lldp config < port-list >

Displays the LLDP port-specific configuration for all ports in

< port-list >, including which optional TLVs and any non-default

IP address that are included in the port’s outbound

advertisements. For information on the notification setting,

refer to “Configuring SNMP Notification Support” on page

12-38. For information on the other configurable settings

displayed by this command, refer to “Configuring Per-Port

Transmit and Receive Modes” on page 12-39.

The blank IpAddress field indicates that the

default IP address will be advertised from this

port. (Refer to page 12-40: “Configuring a Remote

Management Address for Outbound LLDP

Advertisements”

This field appears when dot3tlvenable is enabled

on the switch, which is the default setting.

These fields appear when medtlvenable is

enabled on the switch, which is the default

setting.

Other manuals for HP ProCurve 2510-24

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2510-24 and is the answer not in the manual?

General