HP PROCURVE 6120

6-39
Switch Memory and Configuration
Multiple Configuration Files
TFTP: Copying a Configuration File from a Remote Host
For example, the following command copies a startup-config file named test-
01.txt from a (UNIX) TFTP server at IP address 10.10.28.14 to the first empty
memory slot in the switch:
ProCurve(config)# copy tftp config test-01 10.10.28.14
test-01.txt unix
Syntax: copy tftp config < dest-file > < ip-addr > < remote-file > < pc | unix > [oobm]
This is an addition to the copy tftp command options. Use
this command to download a configuration file from a TFTP
server to the switch.
The oobm parameter specifies that the copy operation will go
out from the out-of-band management interface. If this
parameter is not specified, the copy operation goes out from
the data interface. Refer to Appendix G, “Network Out-of-
Band Management” in this guide for more information on
out-of-band management.
Note: This command requires an empty memory slot in the
switch. If there are no empty memory slots, the CLI displays
the following message:
Unable to copy configuration to "< filename >".
For more on using TFTP to copy a file from a remote host,
refer to “TFTP: Copying a Configuration File from a Remote
Host” on page A-27.