10-10
Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
For example:
ProCurve# show interfaces display
Figure 10-5. Example of show interfaces display Command with Dynamically Updating Output
Customizing the Show Interfaces Command
You can create show commands displaying the information that you want to
see in any order you want by using the custom option.
Syntax: show interfaces display
Initiates the dynamic update of a command. The output is the
same as the equivalent “show” command.The information is
updated every 3 seconds.
Note: Select “Back” to exit the display.
To Next Page
Loading...
