9-18
Time Protocols
TimeP: Viewing, Selecting, and Configuring
ii. Enter the IP address of the TimeP server you want the switch to
use for time synchronization.
Note: This step replaces any previously configured TimeP server
IP address.
iii. Press
[>] to move the cursor to the Poll Interval field, then go to
step 6.
5. In the Poll Interval field, enter the time in minutes that you want for a
TimeP Poll Interval.
Press
[Enter] to return to the Actions line, then [S] (for Save) to enter the new
time protocol configuration in both the startup-config and running-config
files.
CLI: Viewing and Configuring TimeP
CLI Commands Described in this Section
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.
Command Page
show timep 9-19
[no] timesync 9-20 ff., 9-23
ip timep
dhcp 9-21
manual 9-22
server <ip-addr>9-22
interval 9-23
no ip timep 9-24
To Next Page
Loading...
