7-2
Interface Access and System Information
Overview
Overview
This chapter describes how to:
■ View and modify the configuration for switch interface access
■ Use the CLI kill command to terminate a remote session
■ View and modify switch system information
For help on how to actually use the interfaces built into the switch, refer to:
■ Chapter 3, “Using the Menu Interface”
■ Chapter 4, “Using the Command Line Interface (CLI)”
■ Chapter 5, “Using the ProCurve Web Browser Interface”
Why Configure Interface Access and System Information? The inter-
face access features in the switch operate properly by default. However, you
can modify or disable access features to suit your particular needs. Similarly,
you can choose to leave the system information parameters at their default
settings. However, modifying these parameters can help you to more easily
distinguish one device from another in your network.
To Next Page
Loading...
