10-8
Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
CLI: Viewing Port Status and Configuring Port
Parameters
From the CLI, you can configure and view all port parameter settings and view
all port status indicators.
Port Status and Configuration Commands
Viewing Port Status and Configuration
Use the following commands to display port status and configuration data.
An example of the show interfaces brief command is shown below.
show interfaces brief page 10-9
show interfaces config page 10-9
show interfaces custom page 10-10
show interfaces port-utilization page 10-13
show tech transceivers page 10-14
interface page 10-15
disable/enable page 10-15
speed-duplex page 10-15
flow-control page 10-17
broadcast-limit page 10-18
auto-mdix page 10-19
Syntax: show interfaces [ brief | config | < port-list >]
brief: Lists the current operating status for all ports on the
switch.
config: Lists a subset of configuration data for all ports on the
switch; that is, for each port, the display shows whether the port
is enabled, the operating mode, and whether it is configured
for flow control.
< port-list >: Shows a summary of network traffic handled by the
specified ports.
To Next Page
Loading...
Need help?
General