G-15
Network Out-of-Band Management (OOBM)
Tasks
Application Client Commands
CLI commands for client applications have added the oobm keyword to allow
you to specify that the outgoing request be issued from the OOBM interface.
If you do not specify the
oobm keyword, the request will be issued from the
appropriate in-band data interface. Command syntax is:
Telnet:
telnet <ip-address> [oobm]
Management and Configuration Guide, page 7-6
TFTP:
copy tftp ... <ip-address> <filename> ... [oobm]
Management and Configuration Guide, page A-7 and following
SNTP:
[no] sntp server priority <priority> <ip-address> [oobm] [version]
Management and Configuration Guide, page 9-11
TIMEP:
[no] ip timep <dhcp | manual <ip-address> [oobm] > [...]
Management and Configuration Guide, page 9-22
RADIUS:
[no] radius-server host <ip-address> [oobm]
Access Security Guide, page 3-17, page 5-14, page 10-25
TACACS+:
[no] tacacs-server host <ip-address> [oobm]
Access Security Guide, page 4-18
DNS:
[no] ip dns server-address priority <priority> <ip-address> [oobm]
Management and Configuration Guide, page C-82
Syslog:
[no] logging <ip-address> [control-descr] | [oobm]]
Management and Configuration Guide, page C-49
Ping:
ping [...] [source < ip-address | vlan-id | oobm>]
Management and Configuration Guide, page C-59
Traceroute:
traceroute [...] [source <ip-address | vlan-id | oobm>]
Management and Configuration Guide, page C-61
To Next Page
Loading...
Need help?
General