A-30
File Transfers
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
(For more on these commands, refer to “Rebooting the Switch” on page
6-19.)
Copying Diagnostic Data to a Remote
Host, USB Device, PC or UNIX
Workstation
You can use the CLI to copy the following types of switch data to a text file in
a destination device:
â– Command Output: Sends the output of a switch CLI command as a file on
the destination device.
■Event Log: Copies the switch’s Event Log into a file on the destination
device.
â– Crash Data: software-specific data useful for determining the reason for
a system crash.
â– Crash Log: Processor-Specific operating data useful for determining the
reason for a system crash.
The destination device and copy method options are as follows (CLI key word
is in bold):
â– Remote Host via TFTP.
â– USB serial console connected PC or UNIX workstation.
Syntax: boot system flash [ primary | secondary ]
boot system flash [ config < filename >
Switches boot from the designated configuration file. For more
on multiple configuration files, refer to “Multiple
Configuration Files” on page 6-25.
Syntax:
reload
Reboots from the flash image currently in use.
To Next Page
Loading...
Need help?
General