HP PROCURVE 6120

G-16
Network Out-of-Band Management (OOBM)
Tasks
Example
This example shows setup and use of network OOBM using the commands
described above.
Assume that the figure below describes how you want to set up your data
center.
Figure D-3. Example data center
Assume that you are configuring the switch in the left-hand rack to commu-
nicate on both the data and management networks. You might do the follow-
ing:
■ Configure an IP address on the data network.
■ Verify that out-of-band management is enabled. (It is enabled by default.)
■ Configure an IP address on the management network.
■ Verify that the switch can communicate on both networks.
The CLI commands that follow would accomplish those tasks. (The first time
through the process you might easily make the omission shown near the end
of the example.)