13-45
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
For example, show lldp config produces the following display when the switch
is in the default LLDP configuration:
Figure 13-13. Example of Viewing the General LLDP Configuration
Displays the LLDP global configuration, LLDP port status, and
SNMP notification status. For information on port admin status,
refer to “Configuring Per-Port Transmit and Receive Modes” on
page 13-51.
Note: This value corresponds to
the lldp refresh-interval
command (page 13-47).
Med Topology Trap Enabled
-------------------------
False
True
False
False
True
False
False
To Next Page
Loading...
