HP Smart Array errors 118
Message Id: 24610
Severity: Warning
Log message: Array controller <controller name / slot information> has reported that
either redundant I/O module number <module number> in box <box number> was removed
or the cable to this module was removed. The cable and I/O module were connected
to port <port number> of the array controller.
Message Id: 24611
Severity: Informational
Log message: Array controller <controller name / slot information> has reported that
either redundant I/O module number <module number> in box <box number> was added
or the cable to this module was connected. The cable and I/O module are connected
to port <port number> of the array controller.
Message Id: 24612
Severity: Informational
Log message: Array controller <controller name / slot information> has reported that
box <box number> connected to port <port number> is now marked as repaired
(re-added after a previous failure).
Message Id: 24613
Severity: Informational
Log message: Array controller <controller name / slot information> has reported that
either redundant I/O module number <module number> in box <box number> was
repaired or its' path was repaired. Box <box number> is connected to port <port
number> of the array controller.
Message Id: 24614
Severity: Informational
Log message: Array controller <controller name / slot information> has reported that
the external array controller attached to port <port number> has been disconnected
or powered down.
Message Id: 24615
Severity: Informational
Log message: Array controller <controller name / slot information> has reported that
an external array controller was attached to port <port number> or was previously
attached and was powered on.
Message Id: 24616
Severity: Warning
Log message: Array controller <controller name / slot information> is reporting that
an unsupported configuration has occurred with the redundant cabling that is
attached between port <port number> and box <box number>. <firmware information>.
Please check the cabling and ensure that a supported configuration is being used.
<firmware information> values:
• “The Smart Array firmware is reporting that no additional details are
available”
To Next Page
Loading...
