HP ProLiant Gen9 - Page 136

HP Smart Array errors 136
• “ERASING”
• “UNKNOWN”
Message Id: 24711
Severity: Warning
Log message:
The external Smart Array controller located in the MSA chassis labeled as <chassis label> has reported that
logical drive <logical drive number> has encountered a status change from:
Status: <current status>
to
Status: <previous status>
The external Smart Array controller is attached to the host side Smart Array
controller <controller name / slot information>.
<previous status> and <current status> values:
• “OK”
• “FAILED”
• “NOT CONFIGURED”
• “INTERIM RECOVERY MODE”
• “READY FOR RECOVERY”
• “RECOVERING”
• “WRONG PHYSICAL DRIVE REPLACED”
• “PHYSICAL DRIVE NOT PROPERLY CONNECTED”
• “HARDWARE IS OVERHEATING”
• “HARDWARE HAS OVERHEATED”
• “EXPANDING”
• “NOT YET AVAILABLE”
• “QUEUED FOR EXPANSION”
• “DISABLED DUE TO SCSI ID CONFLICT”
• “EJECTED”
• “ERASING”
• “UNKNOWN”
Message Id: 24712
Severity: Error
Log message:
The external Smart Array controller located in the MSA chassis labeled as <chassis
label> has reported that logical drive <logical drive number> has encountered
a status change from:
Status: <current status>