HP ProLiant ML110 G7 Maintenance And Service Guide

Removal and replacement procedures 25
CAUTION: Do not operate the server for long periods with the access panel open or removed.
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
1. Place the access panel on the chassis, and slide it toward the front of the server.
2. Tighten the thumbscrew.
3. Close and lock the bezel.
IMPORTANT: Be sure that the panel is locked into place securely before powering up the server.
4. Power up the server.
Removing the front bezel
1. If performing a non hot-plug installation or maintenance procedure, power down the server ("Power
down the server" on page 23).
2. Unlock and open the front bezel.
3. Pull out the bezel.
Installing the front bezel
1. Insert the bezel.

HP ProLiant ML110 G7 Specifications

General

Product Type	Server
Form Factor	Tower
Processor Sockets	1
Chipset	Intel C202
Memory Type	DDR3 UDIMM
Maximum Memory	16 GB
Memory Slots	4
Processor	Intel Xeon E3-1200 series
Storage	SAS or SATA
Drive Bays	4 LFF or 8 SFF
Hard Drives	Optional
Optical Drive	Optional
Network Controller	HP NC112i Gigabit Ethernet Adapter (1 port)
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Storage Controller	HP Dynamic Smart Array B120i