Removal and replacement procedures 62
General DIMM slot population guidelines
• The server has four memory slots.
• The server supports two channels with two UDIMM slots per channel.
• Memory channel A consists of the two UDIMMs that are closest to the processor.
• Memory channel B consists of the two UDIMMs that are located farthest from the processor.
• Different types of processors have different types of memory support.
• The server supports dual-rank, 1,333 MT/s ECC UDIMMs.
• The server supports up to 16 GB (4x4-GB) for UDIMMs.
• The server does not support:
o LV-DIMMs
o RDIMMs
o Non-ECC UDIMMs
• When installing DIMMs:
o If the processor is not installed, then do not install DIMMs.
o Populate DIMMs from heaviest load (double-rank) to lightest load (single-rank).
o Use HP-qualified UDIMMs.
o The DIMM farthest from the processor (either CHA or CHB) must be populated first.
Installing a DIMM
1. Power down the server (on page 23).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the tower bezel.
4. Remove the access panel ("Removing the access panel" on page 24).
5. Open the DIMM slot latches.
To Next Page
Loading...
