Removal and replacement procedures 37
11. Install the access panel ("Installing the access panel" on page 24).
12. Install the front bezel ("Installing the front bezel" on page 25).
13. Power on the server.
Installing the redundant hot-plug power supply
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
1. Power down the server (on page 23).
2. Remove the front bezel ("Removing the front bezel" on page 25).
3. Remove the access panel ("Removing the access panel" on page 24).
4. Disconnect the power cables from the nonredundant power supply.
To Next Page
Loading...
