Installing the access panel
Procedure
1. Power down the server.
2. Disconnect the power cord from the power source and the server.
3. Remove the bezel.
4. Place the server on its side with the access panel facing up.
5. Install the access panel:
a. Place the access panel on the chassis and slide it toward the front of the server.
b. Tighten the thumbscrew.
6. Install the bezel.
7. Return the server to an upright position.
8. Connect the power cord to the power source and the server.
9. Power up the server.
20 Installing the access panel
To Next Page
Loading...
