8. Install the TPM security rivet by pressing the rivet firmly into the system board.
9. Install the air baffle.
10. Install the access panel.
11. Install the bezel.
12. Return the server to an upright position.
13. Connect the power cord to the power source and the server.
14. Power up the server.
Retaining the recovery key/password
The recovery key/password is generated during BitLocker setup, and can be saved and printed after
BitLocker is enabled. When using BitLocker, always retain the recovery key/password. The recovery key/
password is required to enter Recovery Mode after BitLocker detects a possible compromise of system
integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery key/
password:
• Always store the recovery key/password in multiple locations.
• Always store copies of the recovery key/password away from the server.
• Do not save the recovery key/password on the encrypted hard drive.
70 Retaining the recovery key/password
To Next Page
Loading...
