Procedure
1. Back up all server data.
2. Power down the server.
3. Disconnect the power cord from the power source and the server.
4. Remove the bezel.
5. Place the server on its side with the access panel facing up.
6. Remove the access panel.
7. Remove the air baffle.
8. Remove the EMI shield.
9. Install the drive into the drive carrier and secure it with four T-15 screws included with the option.
10. Secure M3 screws to the drive carrier. M3 screws can be found on the server front panel.
Hardware options installation 51
To Next Page
Loading...
