HP ProLiant ML350 Generation 4p User Manual

Server Operations 27
3. After performing the installation or maintenance procedure, slide the server
back into the rack:
a. Press the server rail-release latches and slide the server fully into rack.
b. Secure the server by tightening the thumbscrews.
Removing the Front Bezel (Tower Model)
This server has a removable front bezel that must be unlocked and opened before
accessing the hard drive cage or removing the access panel. The door should be
kept closed during normal server operations.
Use the key provided with the server to unlock the bezel with a clockwise turn.
If necessary, remove the front bezel.
Removing Access Panel
1. Loosen the two thumbscrews located on the left side on the front of the
chassis.
2. Slide the access panel back about 1.5 cm (0.5 in).
3. Lift and remove the access panel.

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X