HP ProLiant ML350 Generation 4p User Manual

62 HP ProLiant ML350 Generation 4p Server User Guide
11. Connect the data cable into a SCSI controller channel (secondary SCSI
channel shown).
12. Replace the front bezel ("Removing the Front Bezel (Tower Model)" on page
27
), if applicable.
13. Replace the access panel ("Removing Access Panel" on page 27
).
Installing a Tape Drive Option
1. Power down the server ("Powering Down the Server" on page 25).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 26
).
3. Remove the front bezel door, if necessary ("Removing the Front Bezel
(Tower Model)" on page 27
).
4. Remove the access panel ("Removing Access Panel" on page 27
).
5. Install the guide screws ("Identifying Guide Screws" on page 58
), if
applicable.
6. Configure the device by setting the SCSI ID. The SCSI ID on each device
must be manually set to a unique value. Refer to the documentation provided
with the device for instructions on setting the SCSI ID.
7. Install the drive into the drive bay until it clicks into place.

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X