HP ProLiant ML350 Generation 4p User Manual

92 HP ProLiant ML350 Generation 4p Server User Guide
Connecting ATA or ATAPI Devices to the Integrated
IDE Controller
This server includes one IDE cable (the Cable Select Cable) that can connect up
to two ATA or ATAPI devices to the system through the integrated IDE
controller. This cable has three clearly labeled connectors. If only one IDE
device is connected to the system, it must be secured to the cable connector
labeled Drive 0. All IDE devices in the system should have their configuration
jumpers set to "Cable Select" or "CS."
IMPORTANT: If the network operating system is Novell NetWare, HP
recommends that you connect the CD-ROM to the primary IDE channel
and to the Drive 0 connector on the IDE cable.
NOTE: ATA (IDE) hard drives are not supported.

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X