HP ProLiant ML350 Generation 4p User Manual

52 HP ProLiant ML350 Generation 4p Server User Guide
•
•
•
•
•
Online Spare Memory operates with four or six DIMMs.
After installing DIMMs, use RBSU to configure the system for online spare
memory support.
DIMM Installation Guidelines
You must observe the following guidelines when installing additional memory:
Always install DIMM pairs in a memory bank with identical DIMMs.
Install only PC2-3200R DIMMs.
Install DIMMs into both slots within a single bank.
Upgrade memory by installing DIMM pairs into banks in sequential bank
order, starting with bank B.
For online spare memory support, you must also observe additional guidelines.
Installing DIMMs
1. Power down the server ("Powering Down the Server" on page 25).
2. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 26
).
3. Remove the front bezel door, if necessary ("Removing the Front Bezel
(Tower Model)" on page 27
).
4. Remove the access panel ("Removing Access Panel" on page 27
).
5. Open the DIMM slot latches.

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X